Question for Jack at Racetronix

[Intercooler]

I figure you are on this board most so hopefully you will see this.

What is the difference in these two kits?

http://www.racetronix.com/RX-G7-DFH.html


I have the RC dual fans and want to upgrade the wiring to one of these setups. A board member has the one on the right for sale and I am considering buying it. What is different about the one on the left? Can I get the pieces missing to make it the same. Thanks!

[87natty]

And another question, is this harness for both the dual RC fans and the stock fan? What up Mud?

[Intercooler]

Just trying to get my heap back together. Been finally working on it lately. Did you see the pics of the headrests? See below.

Want a nice harness for the fans so I don't get anything hot!

[87natty]

Yup, saw the headrests a while back, put them in my portfolio to boot! They look damn good man. Great concept. :beerglass

[Racetronix]

I figure you are on this board most so hopefully you will see this.

What is the difference in these two kits?

http://www.racetronix.com/RX-G7-DFH.html


I have the RC dual fans and want to upgrade the wiring to one of these setups. A board member has the one on the right for sale and I am considering buying it. What is different about the one on the left? Can I get the pieces missing to make it the same. Thanks!

The one on the left comes with the ground upgrade and battery nuts w/accessory taps. You should buy this system if you do not have a Racetronix fuel pump hotwire harness installed. If you already have the Racetronix fuel pump hotwire harness installed then you should buy the one on the right as you would already have the battery nuts w/ accessory taps and ground upgrade installed.

[Intercooler]

The deal on the one on the right seems pretty decent. Can it be upgraded? What difference will I see?


How does these differ from this one: https://www.casperselectronics.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=109069&Category_Code=8687gnational


I have your injector harness but not FP upgrade.

[Racetronix]

The deal on the one on the right seems pretty decent. Can it be upgraded? What difference will I see?


How does these differ from this one: https://www.casperselectronics.com/Merchant2/merchant.mvc?Screen=PROD&Product_Code=109069&Category_Code=8687gnational


I have your injector harness but not FP upgrade.

We get rid of the small Valeo connector and upgrade it with a 46 amp rated Delphi connector. This connector is the same as the one on the factory harness so you can plug the fans into the factory wiring if required (not that you should ever have to). We use 40A mil spec. relays not 30 amp. We use heavier 10 gauge wire for less voltage drop. You can run HD Spal fans if you wish to! We have independent fuses on each circuit. All our connections are crimped and soldered. The battery nuts we provide have accessory taps on the ends allowing for easy hookup of the harness's power source. Our harness provides a dedicated / upgraded ground source for the fans w/grounding eyelet. The relays are supplied with a dedicated ground from the battery. Our harness is wired so that both fans run high and low speed. Nylon wire ties, spare fuses for RC or Spal fans, SS mounting hardware, dielectric silicon grease etc. Racetronix quality, fit and appearance.

[Intercooler]

This board member is giving a good deal on the one pictured to the right. Can I buy the stuff to upgrade it to the one on the left from you? Is it upgradeable?

[aminga]

Just trying to get my heap back together. Been finally working on it lately. Did you see the pics of the headrests? See below.

Want a nice harness for the fans so I don't get anything hot!

So where did you get the headrest?

[Intercooler]

I had them done by the vendor that does Pro-Pain propane kits. OGS

[Racetronix]

Is it upgradeable?

Do you mean the battery nuts and ground cable.
They can be specially ordered.

[Intercooler]

Do you mean the battery nuts and ground cable.
They can be specially ordered. I guess what I am saying is the one on the right is no different than the one on the left except for the nuts and ground cable? If I get the nuts and ground cable from you I will have made the one on the left? Make sense? :joint:

[Racetronix]

I guess what I am saying is the one on the right is no different than the one on the left except for the nuts and ground cable?

Correct!
Please note we do not sell the nuts and ground cable by themselves to be bundled with 3rd party product.

[Intercooler]

Correct!
Please note we do not sell the nuts and ground cable by themselves to be bundled with 3rd party product. This is your unit on the right. I just want it to be as complete as the one on the left. Can I get these pieces from you? Can you supply the instructions on any splicing that needs to be done to it for the upgrade? Thanks!

[Racetronix]

This is your unit on the right!

:confused: 'This'?

You mean you own a Racetronix DFH and you need these parts?

[Intercooler]

I'm sorry. I am looking to buy one of your 64.99 harness setups from a board member that never installed it. I want to make it like the 74.99 unit. It is one of yours but not the one with brass nuts!

[Racetronix]

I'm sorry. I am looking to buy one of your 64.99 harness setups from a board member that never installed it. I want to make it like the 74.99 unit. It is one of yours but not the one with brass nuts!

Once you get the harness e-mail sales@racetronix.com and we can go from there.

[Intercooler]

The RC dual fans has a harness on it when I bought it. Does this work in conjunction with that harness or would I need to take it off and install this whole unit?

[Racetronix]

The RC dual fans has a harness on it when I bought it. Does this work in conjunction with that harness or would I need to take it off and install this whole unit?

All that you change on the fan assembly is the 4-position connector.
Everything else stays the same.