I measured my...

[ledzeppac]

new turbo in inches.

Stock Turbo- 1 1/5 in
1 3/10 out

New TA60? Mystery 1 3/5 in
1 1/2 out


Please no jokes until I get a couple responses that mean something.

Phil

[DCEPTCN]

Have you used the guide on gnttype.org to identify your turbo? They've even got a pictorial section.....

[ledzeppac]

Have you used the guide on gnttype.org to identify your turbo? They've even got a pictorial section.....

Yes. Mine has alternating inlet compressor wheels which indicates a stocker. But it is larger soooooo, don't know.

I need to call John Craig but I am at work, and the bosses are in the office today, so I can't sneek away.

[brutalsix]

Phil,

The inducer of the compressor wheel should be 60mm. By my calculation that is about 2.35 inches. I believe that the turbine wheel is something around the size of an "O" trim. I'm not sure of the actual diameter. FWIW, John Craig once told me that the stock compressor wheel is nothing more than a 60-1 wheel machined down to a smaller diameter. Therefore they will look the same. It's a nice looking turbo, appears new. Did you get a good deal?

Neal

[87natty]

Hi Neal! That's what I saw, just the O-trim stamp and the fins, but the fins can mean anything.

[ledzeppac]

pms sent :bud: