MAP sensor

[gnxtc2]

I changed my 3 bar MAP sensor to a 3.5 bar MAP sensor. Do I have to change any configurations to the XFI?

I went into fuel cal parameters and tried changing the MAP value to 3.5 but XFI rounded it up to 4 :thinking:

Oh another thing, to log via the abandoned EGR connector are pins b&c used?

Thanks

Billy T.
gnxtc2@aol.com

[HighPSI]

You will have to change it to a 4 bar in the fuel calc parameters. Then redo the Map Sensor calibration in the System Configuration/Sensor Calibration Table. I have an .ict file I could send you when I get back from Salem.