broke map sensor line

[redwolf]

So I was trying to adjust the plastic line that goes into the factory map sensor, and that you can tee into the 3-bar map for turbolink boost sensing, and the damn thing snapped on me. Anybody have any ideas on how to fix it or where i could get a new one and how to hook it up? Also, is it going to hurt the car to be driven around without this hooked up, or is it just for the gauge in the dash? Thanks for any replys.

[Bruce]

So I was trying to adjust the plastic line that goes into the factory map sensor, and that you can tee into the 3-bar map for turbolink boost sensing, and the damn thing snapped on me. Anybody have any ideas on how to fix it or where i could get a new one and how to hook it up? Also, is it going to hurt the car to be driven around without this hooked up, or is it just for the gauge in the dash? Thanks for any replys.

The MAP sensor just runs the LEDs on the dash.
Just Duct Tape over it will get you by.

Pep Boys, and Autozone both carry the line.

[irockwithdirt]

If U are talking about the hard plastic vac. line.........just get some small vac. hose from the parts store and splice it. :fragez: