Larger TH Downpipe Puck

[James West]

Anyone know who sells the larger 1.5" diameter replacement pucks for a TH 3" downpipe? I have an older ss 3" TH downpipe with the 1.375" diameter puck. I'd like to upgrade it to the larger one.

Thanks,

[jmidolo]

Anyone know who sells the larger 1.5" diameter replacement pucks for a TH 3" downpipe? I have an older ss 3" TH downpipe with the 1.375" diameter puck. I'd like to upgrade it to the larger one.

Thanks,


Can you replace that yourself? Looks like it's pressed on or something? Anyways, I would give ATR a call...They can hook you up.

[LikeMy6]

I agree. To my knowledge ATR only makes the 1.5" puck.

[SUPER6]

Keith Mease also has these. I think that is the size in his downpipes. I have got a couple of pucks from him when i was porting stock elbows. I used a flat washer that bearly fit over the shaft of the puck. The shaft had a small hole drilled in it and i would take a punch and spead it out to hold it in the elbow..worked great :add_schac hth.......................Bob :gost:

[jmidolo]

I had forgotten the 1st THs had the smaller diameter puck. That must be an old old one James, that was changed early on I think. KM surely has them too, I would think any DP guy would as they all use 1.5's now anyways that I know of.

[turbofish38]

Hi James, Hows it going? If you can get a puck from Keith have one of your guys weld it on to the arm but make sure they dont weld it to the arm so it can rotate freely. This might eliminate the possibility of it not being centered over the hole. Hey let me know if you find one because I have been fighting mine for the last couple of years as you might know. I may have to hog more off the elbow of the POS BGC downpipe to make it clear but this way I can still look stock to the ricers.